Q&A

No, the glass tube is integrated with hardware of K1 plus tank, you can not disassemble it.

If the wattage range of your coil is 8-12 W, the resistance range of coil is 1.0 ohm -2.0 ohm, and the diameter of tank is less than or equal to 16mm  with a 510 connector ,then you can screw the magnetic metal connecting ring to bottom of your tank and use the tank with […]

Press the bottom mode button twice in rapid succession to adjust the output wattage. The bottom wattage lights will turn on to indicate the level of the output wattage: one light illuminated is 8W, two lights illuminated is 10W, three lights illuminated is 12W.  

1) Screw the metal connecting ring to the bottom of the K1 Plus tank; 2) Insert the tank into the mod, the tank will be magnetically drawn into the mod and be held in place.

No, it doesn’t support a firmware upgrade

Yes, you can twist the airflow ring at base hardware of tank to adjust airflow

While charging or when K1 Stealth kit is in use , the indicator light will indicate your device’s current charge: 3.5 volts or less= red light; 3.5 to 3.8 volts= blue light; 3.8 volts and above =green light.

1)Unscrew the drip tip to remove it from the tank; 2)Place the tip of your filling bottle into the filling hole; 3)Squeeze the filling bottle to add your preferred e-liquid into the tank; 4)Put the drip tip back on top of the tank then screw to secure it.

1)Push down the drip tip and unscrew to remove it from the tank; 2)Add your preferred e-liquid by pushing the tip of your filling bottle through the filling hole; 3)Put the drip tip back on top of the tank then push down and screw at the same time to secure it.

Battery capacity is 1000 mAh