change aspire feedlink battery

How can I install the 18650 battery?

1) Invert the Feedlink mod and unscrew the battery cap. 2) Insert an 18650 battery into the battery compartment with positive end pointing down and negative end pointing up. 3) Screw the battery cap back onto the mod. Note: 1)Please use single 18650 high rate discharge battery(above 35A) 2)Please don’t over tight the battery cap

Read More
aspire squonker kit

How can I install the silicone e-liquid bottle?

1) Lightly push in the bottle securing cap at the bottom of the mod. 2) Then twist counter-clockwise direction to remove the securing cap. 3) Insert a new silicone e-juice bottle into the plastic carrier frame, reinsert the frame into the mod then push the knob and twist clockwise direction to secure.

Read More
aspire squonker kit

How can I change the used coil?

1) Unscrew and remove the top chamber. 2) Unscrew and remove the mounting screw. 3)Remove the used ARC coil by lifting over the metal pin. 4)Place a new coil over the metal pin, make sure the coil edge is well seated and lined up with the tank. 5) Screw the mounting screw back onto the […]

Read More
aspire Feedlink revvo squonk kit

How can I fill the Revvo boost tank?

The Revvo boost tank is fitted with a bottom feeding squonk pin, so you only need to squeeze the squonk bottle until you can see your e-liquid rising into the tank, squeeze again to fill the tank to your requirements but don’t try to overfill, remember you can top up easily with just another gentle […]

Read More