Q&A

We suggest using a wall adapter with an output of 5V/1A.

The TPD version has a 2ml capacity, the regular version has a 3.5ml capacity.

If using the 5V/1A wall adaptor, you need to charge Spryte AIO for about 3 hours.

1)Pull and remove the pod from the main body of the Spryte AIO. 2)Invert the pod then unscrew and pull out the chimney unit. 3)Detach the atomizer from the airflow control ring and replace it with a new one. 4)Screw the chimney unit back to the pod system. 5) Re-inset the pod into the power […]

When the Spryte AIO is fully charged the LED will flash blue and red 20 times then remain off.

No, it doesn’t support firmware upgrades

The Spryte AIO 1.2ohm coil with green seal gasket and NS mark is designed for nicotine salt liquids

1)Pull and remove the pod from the main body of the Spryte AIO. 2)Invert the pod and lift the silicon seal 3)Place the filling bottle/dropper into the pod filling hole. 4) Squeeze the filling bottle/dropper bulb to add your preferred e-liquid into the pod system. 5)Replace the silicone seal firmly. 6)Re-inset the pod into the […]

To adjust the airflow of the Spryte AIO, please remove the pod and rotate the airflow control ring on bottom of the Spryte AIO pod.

No, it will only fire when you press the fire button.