Most of the tanks are made of metal, and metal material will have internal resistance, because the coil installed doesn’t have direct contact with the mod itself, it will add internal resistance of the tank; not only that, the coil temperature will also affect the resistance. That’s why the resistance displayed on the mod is […]
Q&A
How to install batteries correctly on the Speeder mod?
Open the battery door and insert 2 batteries into the battery compartment, please mind positive and negative poles when installing your batteries. Never use wearing batteries.
Why the screen shows “Low Res” ?
When the atomizer attached is shorted, or the coil resistance is less than 1.0ohm, the Speeder will display “Low Res” please install a coil or atomizer that is within the Speeder resistance range.
Why the screen shows “Low Battery” ?
When the Speeder detects the battery charge is less than 2.8V, it will display “Low Battery” for 5 seconds to remind you it is time to charge your batteries.
The mod says “TOO HOT”, what does it mean?
When the control board detects a temperature over 85 degree Celsius/185 degree Fahrenheit, the Speeder will display “TOO HOT” for 5 seconds.
What is the max voltage output for Speeder mod?
The max voltage output for Speeder is 8.4V.
What is the resistance range for Speeder mod?
Speeder mod can fire coil resistance from 0.1 to 3.5ohms. Know more about Aspire Speeder mod, please check: http://www.aspirecig.com/aspire-mods/box-mods/box-mods472.html
To accomplish 2A charge current, what kind of charger should I use?
To accomplish 2A charge current, please make sure your adaptor output is 5V/2A
What is the max charge current on my Speeder mod?
The max charge current can reach up to 2A.
What is CPS? How can I adjust CPS settings on my speeder mod?
CPS is short for Customizable Power Settings. When the mod is in CPS mode, Press up or down button will change the wattage, pressing fire button to select time from 1 to 10 seconds, pressing up and down buttons simultaneously again will exit your Customizable Power Settings.