How do I build the Zero.G RBA?

Unscrew to remove the RBA chamber; Put the prebuilt coil on the build deck correctly. Screw the grub screws down and tighten the coil. Snip off the coil leads and install the cotton wick; Screw the RBA chamber back onto the deck, then remove the RBA 510 adaptor; Unscrew to remove the preinstalled base (use the base hardware replacement tool); Insert the RBA into the pod and screw it (use the base […]

Read More

How to install AVP Pro coils in Zero.G pod?

Pull and remove the pod from the power unit; Invert the pod and replace the used coil with a new one (you can pull out the coil with the provided tool or you can manually pull it out); Insert/secure the pod back. Note: we suggest you empty the pod or keep just a small amount of e-liquid in it […]

Read More

How do I fill the Zero.G pod?

1) Pull and remove the pod from the main body; 2) Invert the pod, lift the silicone seal and add e-liquid through the filling hole; 3) Insert the pod back onto the device. 

Read More

How do I know the battery level of Zero.G?

While charging or when Zero.G is in use, the LED light will indicate your device’s current charge: less than 3.5 volts (0-20%)= red light; 3.5 to 3.8 volts (20-50%)= blue light; above 3.8 volts (50-100%)=green light.

Read More