- Pull and remove the whole top cap;
2) Unfasten the hexagonal screws on the post holes with 1.5 mm Allen
Key;
3) Building the coils and place the built coil on the build deck correctly;
4) Tighten the hexagonal screws with 1.5 mm Allen Key. Snip off the
coil leads;
- Connect with mod to activate to test the built coil;
6) Roll each section of cotton to thread through the coil, saturate
cotton with e-liquid;
- Activate the mod to make sure the coil can produce vapor;
- Put the top cap back into place.
Note: Prebuilt coil and cotton are not included in this package.
