Q&A

Pull and remove the build deck from the pod; Put the prebuilt coil on the build deck correctly; Screw the grub screws down with a screwdriver to tighten the coil. Snip off the coil leads. Preheat the coil at a low wattage;  Insert cotton through the coil. Align the 2 cotton leads into the cotton […]

Pod for Nautilus coils: Remove the pod metal cover and unscrew to remove the drip tip; Take the pod out; Pull out the coil component; Change the used coil; Push the coil component back into the pod; Insert the pod back onto the mod; Screw the drip tip in place and close the pod metal […]

The pod for Nautilus coils: Nautilus 1.6Ω and 1.8Ω coil; Nautilus 2 0.7Ω coil; Nautilus 2S 0.4Ω and mesh 0.7Ω coil; Triton mini clapton 1.8Ω coil. The pod for BP coils: BP 0.6Ω, mesh 0.3Ω, mesh 0.17Ω coil. The Qbix RBA pod: Qbix RBA deck.

The BOXX pod is made of food grade nylon.

The pre-installed drip tip is removable. In addition, the BOXX kit also includes a 510 drip tip adaptor. Users can replace the pre-installed drip tip and install other 510 drip tips with the drip tip adaptor.

The pod for Nautilus coils comes with a coil adaptor, the airflow is adjustable; The BP pod for BP coils, does not have adjustable airflow; Users can adjust the airflow for the Qbix RBA by changing the AFC pin.

1) Unscrew the battery cap; 2) Take out the old 18650 battery and insert a new one into the battery compartment with the positive end pointing in and negative end pointing out; 3) Screw the battery cap back onto the mod. Note: Do not use wearing battery.

The metal part is mainly made of anodized aluminum.

No, it does not support firmware upgrades.

No, it does not support temperature control.